Electric scooter is mainly composed of controller, motor, battery, charger four major parts and body parts.
1, do not replace the charger casually, do not remove the speed limit of the controller.
Control the computer board
The chargers of various manufacturers generally have individual needs, do not replace thecharger at will when you are not sure. If the mileage requirement is relatively long, you must be equipped with multiple chargers for off-site charging, so you can use another charger to make up the charging during the day and the original charger at night. Removing the speed limit of the controller, although it can increase the speed of some cars, in addition to reducing the safety of the car, it will also reduce the service life of the battery.
2. Protect the charger.
The general instruction manual has instructions on protecting the charger. Many users do not have the habit of reading the manual, often in addition to the problem after thinking of looking for the manual to see, often it is too late, so it is very necessary to read the manual first. In order to reduce costs, the charger basically does not do a high vibration resistance design, so that the charger generally does not put in the trunk and basket of the electric bicycle. In special cases, it is necessary to move, and the charger must also be wrapped in foam plastic to prevent vibration bumps. After many chargers vibrate, their internal potentiometer will drift, causing the entire parameter to drift, resulting in an abnormal charging state. In addition, it should be noted that the ventilation of the charger should be maintained when charging, otherwise it will not only affect the life of the charger, but also may cause thermal drift and affect the charging state. This can cause damage to the battery. Therefore, it is also very important to protect the charger
3. Charge every day.
Even if your endurance requirement is not long, and you can use a charge for 2 to 3 days, it is still recommended that you charge it every day, so that the battery is in a shallow cycle state and the battery life will be extended. Some early mobile phone users think that the battery is best to basically use the later charging, this view is not right,lead-acid battery memory benefit is not so strong. Frequent discharge of electricity has a greater impact on the life of the battery. Most chargers may charge 97% to 99% of the battery after the indicator light changes to indicate a full charge. Although only 1% to 3% of the power undercharge, the impact on the endurance can be almost negligible, but it will also form an undercharge accumulation, so the battery is fully charged to continue to float as much as possible after the lamp is fully charged, which is also good for inhibiting battery vulcanization.
4. Timely charging.
After the battery is discharged, the vulcanization process begins, and at the beginning of 12 hours, there is a significant vulcanization. Timely charging, can clear the not serious vulcanization, if not charged in time, these vulcanized crystals will be accumulated and gradually formed into coarse crystals, the general charger for these coarse crystals is powerless, will gradually form a decline in battery capacity, shorten the service life of the battery. Therefore, in addition to charging every day, it is also necessary to pay attention to charging as soon as possible after use, so that the battery power is in a full state as much as possible.
Post time: Jan-10-2022